1. During operation, check the temperature rise of the bearing at the bottom of the head wheel and the reducer once per shift. If you feel hot after touching your hands for about 10 seconds, it indicates that the temperature rise is too high. The cause should be found out, and the bearing should be filled with lubricating oil or cleaning the bearing. , Reducer and other corresponding measures;
2. Fill the bearing at the bottom of the head wheel with grease once a month;
3. During operation, pay attention to observe whether there is abnormal noise, whether the bucket belt is slipping; whether the bearing and reducer are overheated;
4. For every 2 shifts of the newly installed bucket belt (the hoist runs for more than 10 hours under load), adjust the adjusting screw on the base to tighten the belt; after the screw reaches the * bottom end, the bucket belt should be cut to shorten its length, and Re-tension
5. Clean up the accumulated materials in the base of the hoist once a week;
6. Every time the head cover is opened, the materials attached to the cover should be cleaned up; the head cover should be cleaned at least once a month;
7. Before shutting down, stop feeding and run the car empty for 3-4 minutes, and empty without material.





