Henan Excellent Machinery Co., Ltd
+86-18337370596

Comprehensive Fracture Properties Of Mineral Sizers

Apr 06, 2023

DEM is a numerical method developed in the field of geotechnical engineering to simulate the mechanical process of rock mass and particle group. DEM simulates the collision motion between flowing particles. FEM is a discretization method that divides the research object into a finite number of tiny units, and two adjacent units are connected through nodes. mineral sizers converted the external loads acting on the element into equivalent node load vectors according to the principle of static equivalence and then analyzed the corresponding forces. In this paper, unidirectional coupling was adopted, and the data flow obtained from the discrete element was input into the finite element calculation as a load condition, and then the equipment was analyzed statically or dynamically, as shown in Figure 1. The contact load of broken particles on the structure is derived by discrete element calculation, and then converted into the node load of finite element.

mineral sizers

The effect of particles on the structure is analyzed, and the total deformation, equivalent stress and equivalent strain are obtained, which can serve as the basis for further analysis. (1) Establishment of particle model The external contour model of the material sizers is created by three-dimensional modeling software. Small particles are filled in the external contour, and certain forces are applied to make the small particles filled in the contour fully contact and in a balanced and stable state. Then the location coordinates of all the small particles are obtained and the API file is compiled. In this paper, three-dimensional modeling is carried out first, and the material shapes of cube and ellipsoid are established, which are introduced into the discrete element method software EDEM. Overly sparse filling particles will cause the material to burst immediately after filling. For the filling number of small particles, the calculation method is

a VReal=NV Fraction the filling volume fraction in the formula: V the volume of the external contour model of the material: N the filling amount of a small particle; A small particle volume of VFaction. In this paper, the diameter of cuboid particles is 25mm and the number is 137, and the volume after filling is 0.002m3. The diameter of ellipsoid particles is 25mm and the number of filling is 68. The volume after filling is 0.001m3

When small particles are bonded by bonding model (Bond), there will be overlap between particles, the value of which reflects the deformation and fracture resistance of particles. The larger the radius, the larger the deformation of the particle will be ruptured, on the contrary, the smaller deformation will produce rupture. Particle clusters are formed by the adhesion between particles. The size of mineral sizers bonding force is determined by the Critical Normal Stress and the Critical Shear Stress of the material, i.e., the compressive strength and the shear strength.

(2) in the EDEM software, the collision model between particles is selected as Hertz--Mindin with Bond Built--in, and the collision model between particles and geometry is Hertz--Mindin with Bond Built--in, particle volume force model is compiled API file. Set the material properties of the particles and geometry, as well as the interaction properties between the materials, as shown in Table 1. In this paper, b450mm×500mm tooth roller with javelin tooth shape is adopted. Specific parameters are shown in Table 2. 2. The center distance of the double tooth roll L ensures that the distance between the tooth tip of the tooth roll and the tooth surface of another tooth roll is greater than the particle diameter, that is, L> D. The initial position of the 2-tooth roller ensures that the tooth rows are staggered, and the teeth of one roll are placed in the middle of the 4 teeth on the surface of another roll. The number of cubes and ellipsoids is 10, which is generated at a rate of 5,000 s. The simulation process is shown in Figure 4.

(3) Finite element analysis Build DEM Solutions module in Workbench, and import the force situation obtained from EDEM into Workbench. The static system module was established, the geometric model of mineral sizers tooth roll was introduced, and the Mechanical interface was entered. The material, density and Poisson's ratio of ball mill lining plate were defined as. After mesh division, constraints are added to load the force of particles on the tooth roller.


Related Products