Banana screen is a kind of screening equipment with simple structure, convenient operation and large capacity, but some customers will have the problem of screen surface raw materials not going evenly in the operation process. What is the reason for not going, how to solve this phenomenon?
The reasons why the banana screen screening uneven:
1. Vibrating motor steering problem: banana screen using two horizontal vibration motor as vibration screen, steering and divided into clockwise rotation of the motor and flip two kinds, usually two steering is in turn the direction of the electric motor, but if the user is in when to connect power is negative after the will cause a higher rotational motor will appear sieving raw materials will not go;
2. Motor installation position problem: there are three installation positions of banana screen vibration motor are respectively at the bottom, both sides and the upper part. If the installation position of the vibration motor is close to the feeding mouth, the screen surface raw materials will slow down the operation speed of the raw materials eventually stay on the screen surface.
3. Discharge mouth higher than sieve surface height: in the design of banana screen, if the discharge mouth higher than sieve surface, in the production process will appear the problem of raw material stagnation or slow in the screen surface.
4. The feed method to the banana screen is not evenly: In general,we required the feed equipment should feed the material evenly and continuously.Thus,the material can been spread on the mesh surface evenly,the material will been screened evenly and improve the screening efficiency.
Solution for the material screening uneven on the surface of Banana screen:
Banana screen not screening the material evenly in the design of production and power supply problems. When the user is connected to the power supply for the vibration motor, there are wiring methods on the motor prompt. When the user is connected, please read the manual of the linear vibrating screen and the instructions of the motor carefully. After the power supply is successfully connected, the test operation is carried out and the electric steering is observed. After the motor line is connected, if there is still a raw material stalled, it is necessary to check the motor installation position and outlet height. The outlet height can be directly observed, but the installation position of the motor needs technical measurement, so if the above problems occur, please contact the manufacturer directly.
