Steep Angle conveyor is a kind of widely used conveying equipment, because it has large conveying capacity, simple structure, relatively low investment cost, and convenient maintenance and other characteristics and is widely used in food, coal, mining port, wharf, metallurgy, thermal power plant, chemical plant and other industries.Once the conveyor belt fracture occurs, the conveyor belt will accelerate down under the strong force of dead weight and material weight. When falling, the conveyor belt is thrown around, destroying idlers, side pipes, rack cables and electrical equipment and small pieces along the way, resulting in a large accumulation of conveyor belt and materials and production.

From the analysis of a large number of belt breaking accidents, the Steep Angle conveyor belt breaking reasons are as following:
1. Gear motor damage, hydraulic coupling spray or motor reversal;
2. Conveyor belt joint quality problem. Conveyor belt joints are divided into mechanical joints and vulcanized joints, the quality of mechanical joints is far less than vulcanized joints, so now it is rarely used. As far as the vulcanizing joint is concerned, if the vulcanizing temperature and vulcanizing pressure are not controlled as required, the temperature and pressure are unevenly distributed on the vulcanizing plate, the temperature and pressure holding time are not set reasonably, and the use of unreasonable materials will affect the vulcanizing process.
3. A sudden increase in load caused by the involvement of something else in transit. Such as a particularly large mass of objects suddenly mixed in the transport of materials。
4. Stress changes greatly during startup and shutdown. Belt conveyor start and stop will also cause conveyor belt fracture, generally it is best to start the conveyor under no load. Start and stop slowly changing speed.
5. The conveyor belt's own quality is not up to standard, the service life of the conveyor belt is too long, the conveyor belt is overloaded for a long time, and the daily maintenance is not in place.When the conveyor belt reaches its service life, it needs to be replaced in time.
6. Uneven distribution of materials, conveyor belt deviation. Belt conveyor has no load section and overload section, so that the conveyor belt uneven stress.





