Henan Excellent Machinery Co., Ltd
+86-18337370596

Improvement of corrugated sidewall belt conveyor

Sep 06, 2022

Corrugated sidewall belt conveyor is widely used in metallurgy, coal, grain, chemical industry, electric power, building materials and other industries because of its large transmission Angle, small footprint, high efficiency, vertical lifting and convenient maintenance. Is the concrete mixing station,

port loading and unloading, material transport of the main equipment.

Long corrugated sidewall belt conveyor against traditional conveyor installation period, low accuracy, high cost and the machine running when torn belt running deviation, and other defects, according to the years of corrugated sidewall belt conveyor of production experience, absorb foreign advanced technology, the traditional corrugated sidewall belt conveyor structure was improved design, improved conveyor novel structure, easy installation, The whole machine has long service life and low cost.

1.Optimize the fuselage structure and manufacturing process

The main structure of the traditional conveyor is generally welded by channel steel. The overall quality of the frame depends largely on the technical level of the installation workers and the on-site installation conditions, so the installation accuracy is not high. During the operation of the whole machine, the installation accuracy is often not up to the design requirements, so that the belt is easy to run off and aggravate the wear, and finally the equipment can not run normally. In addition, due to the poor overall rigidity of channel steel structure, trusses and auxiliary support frames need to be added to improve the rigidity of the whole machine, resulting in complex equipment structure, long installation cycle and high manufacturing cost.

The fuselage of the improved corrugated sidewall fenders belt conveyor is a web structure of steel plate overall bending, with the longest overall bending of 12m. It is connected by bolts. The fuselage structure is shown in Figure 1.

corrugated sidewall belt conveyor

FIG. 1 Steel plate bending web structure frame

  1. Rack wallboard

  2. Connecting screw holes

  3. Supporting elements

  4. 4. Dust-proof baseboard 5.Connection plate

2. Add guide mechanism to prevent the tape from running off

In the actual operation, the fatal weakness of the traditional corrugated sidewall belt conveyor is: the long-term friction between the belt guard and the turning pressure belt wheel, the vertical roller and the base belt, which causes the belt to wear and tear of the guard and the base belt after a short time of work. Therefore, fundamentally solving the above problems can effectively reduce the use cost of equipment, reduce the time spent in repairing broken tape or replacing tape, and improve production efficiency.

FIG. 2 Steering mechanism of anti-tape deviation

Turning pressure belt pulley

2. Wavy baffle band

3. Tape baffle band

4. Guide triangle belt

5.small pressure belt pulley

The main reason for the above phenomenon is that the traditional baffle conveyor frame adopts welding structure, the installation accuracy is difficult to meet the design requirements, and the baffle and partition on the belt make it impossible to install the allocating roller like the flat belt conveyor, so the belt runs badly. In the past, the base belt was controlled by the vertical roller to ensure the position of the belt, but this turning pressure wheel will at least one side of the long-term contact friction with the belt retaining edge, so that the belt gradually wear and tear.

In order to control the deviation of the tape, the equipment structure has been improved, and the improved structure is shown in Figure 2.

Improvement measures:

(1) In Corrugated sidewall belt conveyor Add two guide triangle belts after overall vulcanization to the empty edges of the wave retaining belt, and process a corresponding guide groove on the turning pressure belt pulley 1. The chiming of the guiding triangle belt and the guide groove ensures that the tape retaining edge does not directly contact with the turning pressure belt pulley.

(2) A number of small pressure wheels with guide slots are set in the middle of the fuselage to limit the rubber belt to run off course, so as to replace the vertical roller and avoid tearing of the base belt caused by extrusion of the vertical roller and the two sides of the base belt and ensure the integrity of the base belt.