Inclined screen aggregate, sand, gravel, stone and so on. Inclined screen Aggregate, sand, gravel, stone and so on. Inclined screen is a high screening efficiency, large throughput screening equipment. However, if there is a problem of low screening efficiency in the process of use, it should be analyzed from the following aspects and find a solution.
Uneven force on the screen surface:
(1) uneven feeding. Inclined screen feeding funnel is inclined screen in hermetically-shaped shape. The feeding belt often deviates and the funnel deposits mud, which leads to uneven feeding, resulting in heavy overload of screen on one side and almost no-load running on the other side, which often results in uneven wear and fast breakage of screen.
(2) screen surface force is too large and uneven fabric. The distance between funnel and Inclined screen feeding end is too high, up to 400mm. When ore enters Inclined screen from funnel, the impact force on the feeding place is too large, resulting in girder fracture and box cracking at the feeding place. After the ore enters the Inclined screen, the distribution is uneven and the ore always runs to one side. Only half of the screen plays the role of screening, resulting in serious ore accumulation on one side and low screening efficiency. Material retention time is too long: the ore moves slowly on the screen, the screen surface accumulated too much ore, up to 200mm thick. Through the screen surface material moving speed measurement, the speed is about 0.2m/s. The ore moving speed is too slow, resulting in too much ore accumulation on the screen surface, so the Inclined screen always runs under overload, which leads to a series of faults, such as fast screen breakage, flexible coupling tearing, spring damage, girder fracture and box cracking.
Inclined screen rectification measures for mining are carried out in the following three aspects to solve the above problems.
1. Add the distributor: In view of the uneven hopper feeding, the funnel is reformed and a distributor is added at the belt feeding place.
The distributor can move left and right according to the deviation of the belt, divide the ore evenly into both funnels and enter the Inclined screen, so that the feeding on both sides is relatively balanced, which can well solve the problem of uneven feeding.
2. Reduce the height difference and adjust the position of the feeding funnel: To solve the problem of excessive impact force, reduce the discharging end of the funnel and circular vibration
The height difference of the screen inlet end is reduced from the original design of 400 mm to 250mm, so that the ore flows smoothly into the Inclined screen, which greatly reduces the impact force of the ore on the Inclined screen and makes the Inclined screen more balanced. The problems such as box cracking and longitudinal beam fracture are effectively solved. At the same time, in order to solve the uneven distribution of ore in the feeding port, widen the feeding funnel in the feeding port, so that the material evenly distributed in the whole screen surface, so that the screening efficiency is greatly improved.
3. Increase the slope of the screen surface and improve the ore movement speed: the ore moves slowly on the screen surface, resulting in thick ore deposit on the screen surface.
Crushing is serious. The main factors affecting the speed of transport are Inclined screen amplitude and screen slope. The amplitude adjustment is accomplished by adding an eccentric block. The practice of adjusting the amplitude of the Inclined screen in production shows that the effect is not obvious. In practice, the Inclined screen Angle can be adjusted between 15 ° and 35°. Based on on-site investigation and analysis, the Inclined screen box slope can be increased from 15 ° to 20°. Under the condition that the feeding amount remains unchanged, the Inclined screen slope is increased to improve the running speed of the ore and reduce the residence time of the ore on the screen. After rectification, in the case of constant amplitude, through the actual calculation of the material movement speed of 20° screen surface slope is 0.6 m/s, in the crushing capacity of 600 t/h, the material on the screen surface does not accumulate ore, ore compaction phenomenon, and can well complete the role of loose, stratification and screening on the screen surface, Processing capacity has increased dramatically.








