Henan Excellent Machinery Co., Ltd
+86-18337370596

Solution to belt deviation during operation of belt conveyor

Nov 15, 2021

Belt deviation is the most common fault when the belt conveyor is running. In order to solve this kind of failure, the key point is to pay attention to the dimensional accuracy of installation and daily maintenance. There are many reasons for deviation, which need to be dealt with differently according to different reasons:

1. Adjust the supporting roller group. When the belt of the belt line deviates in the middle of the belt conveyor, the position of the roller group can be adjusted to adjust the deviation; during manufacturing, the mounting holes on both sides of the roller group are processed with long holes for adjustment. The specific method is which side of the belt is biased, the side of the roller set moves forward in the direction of belt advancement, or the other side moves backward. If the belt deviates in the upward direction, the lower position of the roller set should move to the left, and the upper position of the roller set should move to the right.

2. Install self-aligning roller set. There are many types of self-aligning roller groups, such as intermediate shaft type, four-link type, vertical roller type, etc. The principle is to use blocking or rollers to rotate in the horizontal plane to block or generate lateral thrust to make the belt automatically centripetal to adjust the belt running. Partial purpose. Generally, it is reasonable to use this method when the total length of the belt conveyor is short or when the belt line is running in both directions. The reason is that the shorter belt conveyor is easier to run off and not easy to adjust. However, it is best not to use this method for long belt conveyors, because the use of the self-aligning roller set will have a certain impact on the service life of the belt.

belt conveyor88

3. Adjust the position of the driving roller and the reversing roller. The adjustment of the driving drum and the reversing drum is an important part of the belt deviation adjustment. Because a belt conveyor has at least 2 to 5 rollers, the installation position of all the rollers must be perpendicular to the center line of the belt conveyor length. If the deviation is too large, it will inevitably deviate. The adjustment method is similar to the adjustment of the roller set. For the head drum, if the belt deviates to the right side of the drum, the bearing seat on the right side should move forward, and the belt of the conveyor deviates to the left side of the drum, and the bearing seat on the left side should move forward accordingly. The left side bearing seat or the right side bearing seat can also be moved back. The adjustment method of the tail roller is just the opposite of that of the head roller. After repeated adjustments until the belt is adjusted to a more ideal position, it is best to install its position accurately before adjusting the drive or changing the direction of the drum.

4. Adjustment of the tension. The adjustment of the belt tension is a very important part of the deviation adjustment of the belt conveyor. The two reversing rollers at the upper part of the weight tensioning place should be perpendicular to the vertical direction of the belt in addition to the length of the belt, that is, to ensure that the centerline of the shaft is horizontal. When using spiral tensioning or hydraulic cylinder tensioning, the two bearing seats of the tensioning roller should be translated at the same time to ensure that the axis of the roller is perpendicular to the longitudinal direction of the belt. The specific adjustment method of belt deviation is similar to that of the drum.

5. The adjustment of the deviation of the belt of the two-way running belt conveyor is relatively more difficult than the adjustment of the one-way belt line. In the specific adjustment, you should adjust one direction first, and then adjust the other direction. When adjusting, carefully observe the relationship between the belt movement direction and the deviation trend, and make adjustments one by one. The focus should be on the adjustment of the drive roller and the reversing roller, followed by the adjustment of the idler roller and the adjustment of the material's blanking point. At the same time, it should be noted that when the belt is vulcanized, the force in the length direction of the belt section should be uniform, and the force on both sides of the belt should be as equal as possible when the guide chain is used.