In practical work, the sidewall belt conveyor has to replace the conveyor belt due to the influence of long time use and its own service period. At this time, we have to face a problem, how should we replace the conveyor belt?It is very simple to replace the conveyor belt of the sidewall belt conveyor, but we must follow the steps, otherwise it is easy to cause questions. The detailed steps are as follows:
1.First, according to the belt evacuation route, the traction and auxiliary traction equipment should be arranged in advance. The traction equipment should be used to pull out the belt, and the auxiliary traction equipment should be used to limit the forward speed of the tail end of the belt to prevent slipping.
2.Then pull the tension trolley forward to a larger position to loosen the belt completely.
3. The key is to remove the check device, cleaner and other devices that prevent the rotation of the roller and the passage of tape and clamps. Once this step is done, the rest will be done.
4. After clean removal, put the new belt on the rotating rack, pay attention to the position must be under the belt tensioning counterweight room, belt working surface close to the ground.
5. After the above steps are completed, the hoist is fixed at a distance of 20 meters from the new belt, and the old belt is fixed with a clip.
6. After the clip is fixed on the old belt, the belt at 15 meters below the belt tensioning counterweight should be cut off, and then the broken end of the old belt should be taken out from the window between the belt tensioning counterweight. If the window size is small, the window should be enlarged in advance.
7. Firmly connect the new sidewall belt conveyor belt with the broken end of the old belt, and break the other old belt and jam it with the winch wire rope. Slowly close the rope until it is tight, loosen the clamp on the old belt, continue to close the winch rope and the old belt is pulled down. At the same time, new belts were brought to the sidewall belt conveyor.
8. When the above steps are finished, it is the key step to install the conveyor belt. Pull the new belt with the winch until the broken end of the new belt reaches the appropriate joint position, and cut off the new belt according to the length determined by the new belt (namely, the total length of the belt plus the length of the two joints).
9. When connecting the belt, vulcanization connection must be used, which is more durable. The operation mode of vulcanizing connection is: use vulcanizing machine to bond the belt joint, install the temporarily removed upper supporting stick, put down the tape and tighten the counterweight.
10. Check the working conditions after installation to ensure that the site can be used normally as expected.
Above are the introduction about how do replace the belt for sidewall belt conveyor,if you have any demand,welcome to feel free to contact us.






